You’re probably looking to upgrade your personal security in terms of firearms. But, standard leather holsters seem to lack accessibility. This leaves you in a tough spot looking for better alternatives.
Nothing to freak out about!
Gun magnets give you the edge you’re searching for! Not only for accessibility but also for compatibility! However, the installation can be tricky.
But we assure you, no fancy skills are needed. All you need is a comprehensive guideline.
To help you with this, we have written a detailed article to help you install the gun magnet with ease. This will cover two of the most common methods to install gun magnets: with screws and without it.
So, How to Install Gun Magnet in Car?
Let’s begin!
At First, Why Go For Gun Magnet Installation?
Gun magnets provide easier accessibility than all other holsters when used in cars. The goal is to allow users to reach the gun as soon as possible.
This is especially advantageous for people who travel often. These car gun magnets cost around only 13$ to 20$, which isn’t that much.
Now, there are two methods of installing gun magnets. The first one is with screws. The other method is by using adhesive gun magnets.
We have mentioned both in a step-by-step process below!
Secondly, Important Things to Consider Before the Installation
The first and foremost precaution is to unload the gun before setting it up with the magnet. After setting up, activate the trigger guard, this is vital.
Remember, a gun magnet can hold around 25-30 lbs. So, don’t use any guns that exceed this range.
Moreover, the placement of the gun magnet is important. The most preferable placement would be right next to the central console (gearbox).
Some people place it directly under the dashboard, or below their seats. But this might cause your legs to collide with the magnet. So, choose your placement carefully based on your comfort and leg space.
Finally, How to Install a Gun Magnet with Screws in Your Car?
This requires the usage of a drill machine and a few screws. If you perform the installation process properly, the magnet has no risk of falling off.
So, just follow these steps to accomplish your mission:
- Start off by determining the placement of the magnet.
- Hold the magnet in the placement area. Now, mark the magnet’s screw hole points on the area.
- Remove the magnet, And drill a hole in the marked points.
- Place the magnet in the placement area. Then insert screws in the hole.
- Do the same for all the other holes to secure the magnet in place.
That basically sums up the procedure using screws.
And, How to Install an Adhesive Gun Magnet?
Some people don’t want to drill holes in their cars. Luckily, this method requires you to stick the magnet to your car using tapes. Double-sided 3m tapes are preferred in this method.
These are the steps to install adhesive gun magnets in a car:
- Firstly, to determine the placement of the gun magnet.
- Take a piece of cloth and pour a little bit of rubbing alcohol on it.
- Clean the area where you will place the gun magnet with the cloth. This helps remove all the dust facilitating the magnet sticking to the area.
- Next, clean the backside of your magnet.
- Wait for the back of the magnet and the placement area to dry.
- Once dried, take your adhesive tape and peel the yellow side of the tape.
- Place it on the backside of your magnet. If your magnet also has screw holes, make sure not to cover them. Peel the other side of the tape and stick it to the placement area.
- Press and hold that position for 45-60 seconds. The magnet should stick firmly.
That covers the adhesive method. Additionally, you can choose to also use screws if the magnet has holes. This provides an extra layer of security.
Final Words
That’s about it for this topic folks! We hope you now have a thorough understanding of how to install gun magnet in car. Good luck with the installation process! And remain safe at all times!
